裂紋線英文

• fault line

• "裂紋" 英文翻譯 :    crack; fissures
• "線" 英文翻譯 :    thread; string; wire
• "紋線" 英文翻譯 :    dermal ridge
• "布紋線" 英文翻譯 :    grain mark
• "螺紋線" 英文翻譯 :    thread
• "條紋線" 英文翻譯 :    streak line
• "裂紋" 英文翻譯 :    flaw; fissure; chine; gash; [房] craze; crazing; crackle (on pottery, porcelain, etc.) 這只碗上有條裂紋。 the bowl has a crack in it.; 裂紋檢測 crack detection; 裂紋探測儀 [冶金學] crack detector; 裂紋涂料 crackle coating
• "波浪紋線步" 英文翻譯 :    wavy stitches
• "波紋線腳" 英文翻譯 :    cyma
• "波紋線毯" 英文翻譯 :    ri le chenille read; ripple chenille spread
• "錯布紋線" 英文翻譯 :    wrong grain line cutting (horizontal to vertical)
• "雕刻斜紋線" 英文翻譯 :    shade-line
• "粉紋線圖" 英文翻譯 :    line diagram of powder pattern
• "復雙紋線組" 英文翻譯 :    multiple twin quad
• "黃色紋線" 英文翻譯 :    yellowband
• "具條紋線" 英文翻譯 :    striated strand
• "浪紋線腳" 英文翻譯 :    cyma
• "連續螺紋線" 英文翻譯 :    continuous thread
• "螺紋線數" 英文翻譯 :    number of leads
• "齊頭線(斜紋線)" 英文翻譯 :    definite end lines
• "凸紋線圈" 英文翻譯 :    raised loop
• "紋線長身蜿" 英文翻譯 :    linoproductus
• "斜紋線跡" 英文翻譯 :    diagonal stitch
• "折射差紋線" 英文翻譯 :    schrodinger pattern
• "直紋線匯" 英文翻譯 :    rectilinear congruence

• Then check that the light energy orb is solid in construction and free of cracks and lines and if it is solid then well done
  然后檢查光能量球構造堅固以及無裂縫和裂紋線而如果它是堅固的然后做得不錯的話。
• Then check that the light energy star is solid in construction and free of cracks and lines and if it is solid then well done
  然后檢查光能量星構造堅固以及無裂縫和裂紋線而如果它是堅固的然后做得不錯的話。
• Then check that the light energy wall is solid in construction and free of cracks and lines and if it is solid then well done
  然后檢查光能量墻構造堅固以及無裂縫和裂紋線而如果它是堅固的然后做得不錯的話。
• Then check that the light energy spear is solid in construction and free of cracks and lines and if it is solid then well done
  然后檢查光能量矛構造堅固以及無裂縫和裂紋線而如果它是堅固的然后做得不錯的話。
• Then check that the light energy bubble is solid in construction and free of cracks and lines and if it is solid then well done
  然后檢查光能量泡構造堅固以及無裂縫和裂紋線而如果它是堅固的然后做得不錯的話。
• The near crack line analysis method is used to investigate an eccentric crack loaded by shear forces in a finite plate , and the analytical solution are obtained
  摘要利用裂紋線場方法對巖石材料偏心裂紋板受剪應力作用時進行了彈塑性分析，并且獲得了理論解。
• The results are sufficiently precise near the crack line because the assumptions of the small scale yielding theory have not been made and no other assumption have been taken
  該分析不受小范圍屈服假設的限制，并且不附加假設條件，其結果在裂紋線附近足夠精確。
• The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87 . 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis , not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi
  得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 “角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器制造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
• The solutions include : the unit normal vector of the elastic - plastic boundary near the crack line , the elastic - plastic stress fields near crack line , law that the length of the plastic zone along the crack line is varied with an external loads , the maximum lengths of the plastic zone , the bearing capacity of a finite plate with an eccentric crack loaded by shear forces
  這個解包括：裂紋線附近彈塑性邊界上的單位法向矢量，裂紋線附近的彈塑性解析解、最大塑性區長度、裂紋線上的塑性區長度隨荷載的變化規律及其承載力。